HEART sensors.noisy H-08004
Readings noisy. Readings jump around far more than normal.
| Code | HEART sensors.noisy; inside a message "code": "sensors.noisy" |
|---|---|
| H-number | H-08004: area 08, code 004 |
| Area | sensors: Readings and calibration |
| Typical severity | warning. A product may set another for its own case. |
| Applies to | Products with sensors: thermostats, chargers, pumps, printers, trackers, medical devices |
Likely causes
- Electrical interference from motors, chargers or radios.
- A loose connection or poor earth.
- A damaged cable shield.
- A sensor near the end of its life.
How to fix or prevent it
- Check connections and earthing.
- Move cables away from power lines and motors, or use shielded cable.
- Replace the sensor if the noise stays.
What the HEART does by itself
It raises a warning and may smooth or ignore the noisy readings. It resolves when the readings are steady again.
When to call service
At once for medical devices, where noise can be mistaken for real signals. Otherwise if it stays after checking connections.
Related codes
sensors.out-of-rangeH-08002: Reading out of rangesensors.disagreeH-08006: Sensors disagreepower.supply-unstableH-02002: Power supply unstable
Inside a message a code is written bare, "code": "storage.full". In logs, tickets, documents and searches it is written
HEART storage.full. Things that simply happen, such as system.started, are event types, not faults.
The codes are defined in Part 3, Section 5.4, and their H-numbers in Section 5.7.
All of it, as data: fault-codes.json.
All fault codes, by area · All fault codes, by H-number · Problem types (API errors)